Please see the first 4 steps in the previous chapter if you have not yet configured your device in TIA Portal.Scanning for devices with TIA Portal or PRONETA is supported on the IXrouter2 in firmware 2.9 and up, and on the IXrouter3 in firmware 3.4 and up.
Siemens Pol687 IP Address Default Upgrade Your FirmwarePlease upgrade your firmware if you are running an older version. The devices used in this guide are a Simatic S7-1200 and a LOGO 0BA7 from Siemens. The IP address needs to share the subnet of your IXrouter but cannot match their exact IP address. The subnet could for example be 192.168.140, meaning the last figure.1 can vary anywhere from 1 to 254 as long as its different from the IXrouter. The subnet mask needs to be the same as the IXrouter, which is usually 255.255.255.0. The (default) gateway should be set to the IP address of the IXrouter. Use the leftright arrow keys (selection) and the updown arrow keys (change value) to change values. To configure a Pure variant, you first need to be connected to your LOGO controller. If only one interface is active at your PC, then LOGOSoft Comfort should find the LOGO controller, independent of its IP address. If LOGOSoft Comfort is unable to find your LOGO controller, you can try to connect to your controllers default IP address: 192.168.0.1 or 192.168.0.2. ![]() Siemens Pol687 IP Address Default Download To TheIf you are unable to download to the device, try pressing Refresh in the bottom right corner or changing an action in the right column. Your configuration is now being loaded into the Siemens controller. The following steps require you to be connected to your IXrouter. On a Mac you may receive a message saying Unable to access the remote device. Once youve followed the instructions, youve remotely accessed your device easy and secure.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |